Configuring amatps

The LayGO AMATPS collector for the PXS is amatps. The PXS should configured to run amatps as the default application. To define this, at the RedBoot prompt enter:

RedBoot> default
Default application: hdlcsrv
RedBoot> default amatps
Default application: amatps

Now amatps will automatically run when the RedBoot timeout expires.

amatps needs the IP address of the file server running Remote File Server to which it should send the files it donwloads from the switch. To set the file server, use the RedBoot ftp command. For instance, if the IP address of the remote file server is 192.168.250.3, enter:

RedBoot> ftp 192.168.250.3
FTP Server: 192.168.250.3

You should also enable remote logging by setting the address of a server running the remote log server. For instance, if the IP address of the remote log server is also 192.168.250.3, enter:

RedBoot> log 192.168.250.3
Log Server: 192.168.250.3
RedBoot> logging enable
Logging: enabled

Command Line Options

amatps supports the following command line options. These may be set using the RedBoot options command.

[-a]

  Do not autostart the client. The client must be started maually
  using the PXS control application.
  Default: Autostart the client

[-b <block count>]

  Number of blocks per primary file to request.
  Default: 100

[-d <start delay>]

  Number of minutes to delay the first primary poll.
  Default: Start without delay

[-f <cfg file>]

  LayGO cfg file.
  Default: amatps-dte.cfg

[-h]

  Disables inclusion of primary and secondary AMA file headers in data files.
  Default: Include headers

[-l <port number>]

  Port 0 or 1 to use for the X.25 connection.
  Default: 0

[-o <poll timeout>]

  Number of minutes to wait between primary polls.
  Default: 60

[-p <block pad>]

  Number of pad bytes to append to each data block.
  Default: 0

[-s <SUN:type:id-SUN:type:id>]

  AMA authentication data for the collector (first) and switch (second).
  The data entered must match the AMA configuration of the switch or the
  session cannot be established.  This parameter is required, even if all
  values are 0, unless the -x parameter is used.
  Default: <none>

[-t <file tag>]

  Unique tag for identifying the source of files to the
  Remote File Server.
  Default: The PXS host name

[-x]

  Disable AMA session authentication check.
  Default: Enabled